77
SetupSetup
1. Audio1. Audio
Speaker Impedance (Default Value: 6 ohms or above)
• For impedance, check the indications on the back of the speakers or their
instruction manual.
4ohms
continuously.
6 ohms or above
or more
Maximum Volume (Default Value: O)
Set the maximum value to prevent the volume from becoming too loud. Select
Power On Volume (Default Value: Last)
Set the volume level of when the power is turned on. Select a value from "Last"
(Volume level before entering standby mode), "Min", "0.5" to "99.5" and "Max".
• You cannot set a higher value than that of "Maximum Volume".
Zone 2 Output Level (Default Value: Fixed)
room or on this unit when outputting to the separate room (Zone 2).
Fixed
Variable Adjust on this unit
Zone 2 Maximum Volume (Default Value：O)
Set the maximum value for Zone 2 to avoid too high volume. Select a value
Zone 2 Power On Volume (Default Value：Last)
Set the Zone 2 volume level of when this unit is turned on. Select a value from
"Max".
• You cannot set a higher value than that of "Zone 2 Maximum Volume".
AM/FM Frequency Step (North American models) (Default Value:
10 kHz / 0.2 MHz)
Select a frequency step to suit your residential area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets are deleted.
To Next Page
Loading...
