Integra DTM-7.4 - Trigger a; Trigger B

86
Setup
6. 12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V
TRIGGER OUT A jack. You can enable power link operation when you connect
the unit and the external devices equipped with 12V trigger input jack.
 Delay (Default Value: 0 sec)
Set after how many seconds the 12V trigger output will occur in response to

delay the output if such devices are connected. Select a value between "0 sec"
to "3 sec".
 BD/DVD (Default Value: Main)
GAME (Default Value: Main)
CBL/SAT (Default Value: Main)
PC (Default Value: Main)
CD (Default Value: Main)
TV/TAPE (Default Value: Main)
PHONO (Default Value: Main)
TUNER (Default Value: Main)
NET (Default Value: Main)
BLUETOOTH (Default Value: Main)
Set the 12V trigger output setting to each input.
󰀨 When the control signal is not output
Main When controlling the power of external devices linked to the
input selection in the main room
Zone 2 When controlling the power of external devices linked to the
input selection in ZONE 2
Main/Zone 2 When controlling the power of external devices linked to the
input selection in the main room or in ZONE 2
7. 12V Trigger B
Set when outputting the control signal (maximum 12 V/25 mA) through the 12V
TRIGGER OUT B jack. You can enable power link operation when you connect
the unit and the external devices equipped with 12V trigger input jack.
 Delay (Default Value: 1 sec)
Set after how many seconds the 12V trigger output will occur in response to

delay the output if such devices are connected. Select a value between "0 sec"
to "3 sec".
 BD/DVD (Default Value: Zone 2)
GAME (Default Value: Zone 2)
CBL/SAT (Default Value: Zone 2)
PC (Default Value: Zone 2)
CD (Default Value: Zone 2)
TV/TAPE (Default Value: Zone 2)
PHONO (Default Value: Zone 2)
TUNER (Default Value: Zone 2)
NET (Default Value: Zone 2)
BLUETOOTH (Default Value: Zone 2)
Set the 12V trigger output setting to each input.
󰀨 When the control signal is not output
Main When controlling the power of external devices linked to the
input selection in the main room
Zone 2 When controlling the power of external devices linked to the
input selection in ZONE 2
Main/Zone 2 When controlling the power of external devices linked to the
input selection in the main room or in ZONE 2