Mechanical
613768 67
Figure 5-14: 3 mm SATA Power 6 Pin Cable Connector – Key and Pin Locations (Bottom
View)
SATA - 6 pin power cable that supports 4 SATA drives per cable is available from the
following companies.
Table 5-17: SATA Power Cable Supporting 4 SATA Devices Part Numbers
Company
SATA Power Cable Supporting
4 SATA Devices
JOINT TECH ELECTRONIC* W30051
Weison* AB9980-0341-007-00
Other cable companies may also be able to manufacturer this cable. Work with your
preferred connector and cable company to verify if they can provide the SATA power
cable described in this document.
5.3.2 Serial ATA Connectors (Reference)
This connector will be used on the Storage Device cable coming from the
motherboard.
This is a required connector for systems with Serial ATA devices. The detailed
requirements for the Serial ATA Power Connector can be found in the Serial ATA: High
Speed Serialized AT Attachment Specification, Section 6.3 Cables and Connector
Specification (http://www.serialata.org/).
Note: Connector pin numbers and wire numbers are not 1:1. Carefully check to confirm the
correct arrangement.
Assembly: Molex* 88751 or equivalent.
To Next Page
Loading...
Need help?
General
