Intel
®
Ethernet Network Adapter E810-XXVDA4T
User Guide
34 646265-004
— ubxtool
ubxtool is an original vendor-supported tool that can make use of u-Blox vendor commands on
support protocol version 29.20 to ZED-F9T-00B. If the 5G deploy environment does not allow
you to use the Desktop environment, you can consider ubxtool as efficient CLI for local and
remote access.
• The default setting of the E810-XXVDA4T configuration minimizes NMEA sentence message
for better timing usage. Only “GNRMC” and “GNGGA” are needed for 5G timing usage. For
better understanding of NMEA sentence focus and its purpose, refer to:
https://w3.cs.jmu.edu/bernstdh/web/common/help/nmea-sentences.php
• The ZED-F9T-00B module requires protocol 29.20, so it needs ubxtool v3.24+. Use the
following command to double check the ubxtool you install:
# ubxtool -V
ubxtool: Version 3.24.1~dev
Did this document help answer your questions?
To Next Page
Loading...
Need help?
General