Chapter 5 – Troubleshooting
59
protocol properly installed with “Frame type” set to
802.3 on the protocol’s Advanced tab.
• Also make sure that Client for Microsoft Networking
and File and Print Sharing are properly installed, as
described below:
Windows 98 or ME
1 Click Start > Settings > Control Panel > Network.
2 To add file and print sharing, click File and Print
Sharing and then click OK.
3 Follow the onscreen prompts to insert your Windows
CD and allow your PC to copy the necessary files.
4 To add a client such as Client for Microsoft Networks
or a network protocol, click Add.
5 Choose from among the subsequent dialog boxes
according to what you want to add and then click OK.
6 Follow the screen prompts to insert your Windows
CD, and your PC copies the necessary files.
Windows 2000
1 Click Start > Settings > Control Panel > Network
and Dial-up Connections.
2 To add file and print sharing or a client or protocol,
right-click the icon representing the network
connection your changes should apply to.
3 Click Properties.
4 Click the Install button and select either client,
service or protocol according to what you want to
add.
Note If you are using AnyPoint adapters, this is all
taken care of automatically.
user_guide_rg1210.book Page 59 Monday, April 22, 2002 2:20 PM
To Next Page
Loading...
Need help?
General
