Chapter 1 – Overview
9
Configuration software and settings
The gateway has internal settings that control the
wireless local area network (WLAN). The gateway also
has settings to control the broadband modem, called ISP
settings. It is important to correctly enter these settings.
Accessing the configuration software
To enter WLAN or ISP settings for the gateway, use the
gateway configuration software. This software is in read-
only memory (ROM) inside the gateway.
Step-by-step 1 Click Start > Programs > Intel AnyPoint > Intel
Wireless Gateway II 1210 > Network Setup Utility.
2 When prompted to change the gateway settings, click
Yes.
or
• Open a browser (either Microsoft Internet Explorer*
or Netscape Navigator*) and type the gateway’sIP
address, 192.168.0.10 (unless you changed the
default gateway IP address).
If you have not filled out the Install Information
Worksheet, do so now. The worksheet helps you gather
and record wireless and ISP settings that you need to
configure the gateway.
Following are brief descriptions of both types of settings
and how they are used.
Wireless
settings
Wireless settings determine which wireless devices can
communicate with the gateway. The wireless settings on
the PC's adapter must match the gateway's wireless
settings before the two devices can communicate.
user_guide_rg1210.book Page 9 Monday, April 22, 2002 2:20 PM
To Next Page
Loading...
Need help?
General
