Chapter 8 – Regulatory Compliance Statements
90
Disassembly steps:
1 Remove the label located at the bottom of the unit –
to access the single phillips head screw.
2 Remove the single phillips head screw located at the
bottom of the unit.
3 Locate two slots on the right-side of the unit.
4 By inserting a small flathead screwdriver first into one
of the slots then the other, slowly pry the top cover off
the unit.
5 You can now recycle the plastic case as well as the
internal circuit boards.
user_guide_rg1210.book Page 90 Monday, April 22, 2002 2:20 PM
To Next Page
Loading...
