Intel S1200BTS User Manual

Intel® Server Board S1200BT TPS Appendix A: Integration and Usage Tips
Revision 1.0
Intel order number G13326-003
119
Appendix A: Integration and Usage Tips
 When adding or removing components or peripherals from the server board, AC power
must be removed. With AC power plugged into the server board, 5-Volt standby is still
present even though the server board is powered off.
 When updating BIOS and BMC, AC power must be on.
 Supports only Intel
®
Xeon
®
Processor E3-1200 Series with 95 W or Intel
®
Core™
Processor i3-2100 and less Thermal Design Power (TDP). Does not support previous
generations of the Intel
®
Xeon
®
processor.
 On the back edge of the server board are diagnostic LEDs that display a sequence of
amber POST codes during the boot process. If the server board hangs during POST,
the LEDs display the last POST event run before the hang.
 Supports only unbuffered DDR3 DIMMs (UDIMMs). Does not support the mixing of
RDIMMs and UDIMMs.
 The Intel
®
Remote Management Module 4 (Intel
®
RMM4) lite connector is not compatible
with the Intel
®
Remote Management Module (Product Order Code - AXXRMM), Intel
®
Remote Management Module 2 (Product Order Code - AXXRMM2) or Intel
®
Remote
Management Module 3 (Product Order Code – AXXRMM3)
 Clear the CMOS with the AC power cord plugged in. Removing the AC power before
performing the CMOS clear operation causes the system to automatically power up and
immediately power down after the CMOS clear procedure is followed and AC power is
re-applied. If this happens, remove the AC power cord, wait 30 seconds, and then re-
connect the AC power cord. Power up the system and proceed to the <F2> BIOS Setup
utility to reset the needed settings.
 Normal Integrated BMC functionality is disabled with the force Integrated BMC update
jumper set to the ―enabled‖ position (pins 2-3). The server should never be run with the
Integrated BMC force update jumper set in this position and should only be used when
the standard firmware update process fails. This jumper should remain in the default
(disabled) position (pins 1-2) when the server is running normally.
 When performing a normal BIOS update procedure, the BIOS recovery jumper must be
set to its default position (pins 1-2).

Intel S1200BTS Specifications

General

Chipset	Intel C204 Chipset
Form Factor	MicroATX
Processor Socket	LGA 1155
Number of Processors Supported	1
Number of Memory Slots	4
Processor Support	Intel Xeon E3-1200 series
Memory Support	DDR3 ECC UDIMM
Expansion Slots	1 PCI-E x16 Gen3, 1 PCI-E x4 Gen2, 1 PCI-E x1 Gen2, 1 PCI 32bit/33MHz
Storage	4 x SATA 3Gb/s, 2 x SATA 6Gb/s
Network Interface	Dual Gigabit Ethernet ports
Memory Speed	1333 MHz
RAID Supported	RAID 0, 1, 5, 10
USB Ports	4 rear