Intel S3210SHLX - Entry Server Board Motherboard - Chassis Intrusion Header; HDD Active LED Header; Ipmb; Hsbp

Intel® Server Boards S3200SH/S3210SH TPS Connectors and Jumper Blocks
Revision 1.3
92
TBD
Figure 34. Intel
®
Server Board S3200SH-V Back Panel I/O Connectors
6.7.2 Chassis Intrusion Header
A 1x2 pin header (J6J2) is used in chassis that support a chassis intrusion switch. This header
is monitored by the Intel
®
ICH9R. The pin-out definition for this header is shown below.
Table 62. Chassis Intrusion Header (J1B2) Pin-out
Pin Signal Name
1 FP_INTRUDER_HDR_P1
2 FP_INTRUDER_HDR_N
6.7.3 HDD Active LED Header
There is a 1x2 pin header for HDD LED connection. This jumper is reserved for PCI add-in
cards that support the SCSI or SATA interface with an external HDD LED activity cable.
Table 63. HDD LED Header (J1J1) Pin-out
Pin Signal Name
1 FM_SIO_SCSI_ACT_N
2 TP_SCSI_ACT_PIN2
6.7.4 IPMB
There is a 4-pin IPMB connector jumper. This jumper is reserved for connecting add in server
management module.
6.7.5 HSBP
There is a 4-pin HSBP connector jumper. This jumper is reserved for connecting to the Intel
®
Entry Server Chassis SC5299-E hot-swap backplane.
6.7.6 SATA SGPIO
There is a 4-pin SATA SGPIO connector jumper. This jumper is reserved for connecting to the
Intel
®
Entry Server Chassis SC5299-E SATA hot-swap backplane.