Intel® Server Boards S3200SH/S3210SH TPS Absolute Maximum Ratings
Revision 1.3
94
7. Absolute Maximum Ratings
Operating the server board at conditions beyond those shown in the following table may cause
permanent damage to the system. The table is provided for stress testing purposes only.
Exposure to absolute maximum rating conditions for extended periods may affect system
reliability.
Table 64. Absolute Maximum Ratings
Operating Temperature
5 °C to 50 °C
1
Storage Temperature
-55 °C to +150 °C
Voltage on any signal with respect to ground -0.3 V to Vdd + 0.3V
2
3.3 V Supply Voltage with Respect to ground -0.3 V to 3.63 V
5 V Supply Voltage with Respect to ground -0.3 V to 5.5 V
Notes:
1. Chassis design must provide proper airflow to avoid exceeding the processor maximum
case temperature.
2. VDD is the supply voltage for the device.
7.1 Mean Time Between Failures (MTBF) Test Results
This section provides results of MTBF testing done by a third party testing facility. MTBF is a
standard measure for the reliability and performance of the board under extreme working
conditions. The MTBF was measured at TBD hours at 35 degrees C.
7.2 Calculated Mean Time Between Failures (MTBF)
The MTBF (Mean Time Between Failures) for the server boards as configured from the factory
is shown in the table below.
Table 65. MTBF Data
Product Code Calculated MTBF Operating Temperature
Intel
®
Server Board S3200SH-L 282569 Hours 35 degrees C
Intel
®
Server Board S3200SH-V 111326 Hours 55 degrees C
Intel
®
Server Board S3210SH-LX 265866 Hours 35 degrees C
Intel
®
Server Board S3210SH-LC 104745 Hours 55 degrees C
To Next Page
Loading...
