Intel SE7500CW2 - On Board Device Submenu

System BIOS SE7500CW2 Server Board Technical Product Specification
58
Revision 1.40
Feature Choices Description
Mode
(This feature is present
only when Parallel Port is
set to enabled)
Output only
Bi-directional
EPP
ECP (default)
Sets the mode for the parallel port.
Output only is the standard printer connection
mode.
Bi-directional is the standard bidirectional mode.
EPP is Enhanced Parallel Port mode, a high-speed
bidirectional mode. Selection based on what EPP
version the printer supports. Only choose a mode
that the parallel port device (such as a printer)
supports. Check the parallel port device
documentation for this information. If this
information cannot be located, use the default
setting.
ECP is Extended Capabilities Port mode, a high-
speed bidirectional mode.
Base I/O Address
(This feature is present
only when Parallel Port is
set to enabled)
378 (default)
278
3BC
Sets the base I/O address for the parallel port.
Interrupt
(This feature is present
only when Parallel Port is
set to enabled)
IRQ5
IRQ7 (default)
Sets the interrupt for the parallel port.
DMA channel
(This feature is present
only when Parallel Port is
set to enabled)
DMA 1
DMA 3 (default)
Sets the DMA channel for the parallel port.
Floppy disk controller Disabled
Enabled
(default)
Enables or disables the onboard diskette controller.
6.5.6.2 On Board Device Submenu
To access this submenu, select Advanced on the menu bar at the top of the screen and then On
Board Device.
Main Advanced Security Power Boot System Exit
I/O Device Configuration
On Board Device
PCI Configuration
Server Menu
Console Redirection
Event Logging
Hardware Monitor
Table 22 lists the options available through the On Board Device submenu. This submenu
configures the RAID, network, and USB controllers on the board.