SE7500CW2 Server Board Technical Product Specification Error Reporting and Handling
75
Revision 1.40
Tpoint Description
Fade out OEM screen.
Reset video: clear screen, reset cursor, reload DAC.
ENDIF
ENDIF
B6h If password on boot is enabled, a call is made to Setup to check password. If the user does not enter a
valid password, Setup does not return.
B7h Initialize ACPI BIOS.
B9h Clear all screen graphics before booting.
BAh Initialize the SMBIOS header and sub-structures.
BCh Clear parity-error latch
BDh Display Boot First menu if MultiBoot is installed.
BEh If BCP option is enabled, clear the screen before booting.
BFh Check virus and backup reminders. Display System Summary.
C0h Try to boot with INT 19
C1h Initialize the Post Error Manager.
C2h Write PEM errors.
C3h Display PEM errors.
Note: Warm start only tasks are shaded, the Cold Start only tasks have heavy border.
Table 36: Crisis Disk Boot Block BIOS POST task point
Tpoint Description
80h Initialize the chipset
81h Initialize the bridge.
82h Initialize the CPU.
83h Initialize system timer.
84h Initialize system I/O
85h Check force recovery boot.
86h Check sum BIOS ROM.
87h Go to BIOS
88h Initialize Multi Processor.
89h Set Huge Segment.
8Ah Initialize OEM special code.
8Bh Initialize PIC and DMA.
8Ch Initialize Memory type.
8Dh Initialize Memory size.
8Eh Shadow Boot Block.
8Fh System memory test.
90h Initialize interrupt vector.
91h Initialize Run Time Clock.
92h Initialize video.
93h Initialize System Management Mode.
94h Output one beep
95h Boot to Mini DOS.
96h Clear Huge Segment
To Next Page
Loading...
