Appendix B: SE7500CW2Errata documentation
SE7500CW2 Server Board Technical Product Specification
CXIV
Revision 1.40
Status No fix. This is a limitation of the core Pheonix* BIOS. The “Network Boot”
selected item in the “Boot” Menu is an unsupported legacy network boot ROM.
The “PXE Support” (BBS) enabling no longer concurrently updates the “Boot”
Menu in this core Pheonix* BIOS.
6. BIOS Boot menu doesn’t differentiate between an IDE CD-ROM
and USB CDROM boot device.
Problem BIOS is unable to display the difference between a IDE CD-ROM and a USB
CDROM. Both devices will be displayed as a “CD-ROM Drive” under <F2>
setup “BOOT” sub-menu.
Implication If you concurrently install an IDE and an USB CD-ROM on SE7500CW2 you will
be unable to determine which device is first in the boot-order in BIOS 1.17 and
below.
Workaround Install the USB and IDE CD-CDROM separately. Between the installation of
first device, say the USB CD-ROM, take note that this is the first device listed in
the boot menu. Reboot and install the IDE CD-ROM. This will now be the
second CD-ROM listed. Devices will be listed according to the order of
installation.
Status Intel is investigating the possibility of fixing this erratum.LDCM 6.3 Wake on LAN
not rebooting the server.
7. Wake on LAN funcitioning incorrectly.
Problem Wake on LAN may not reboot the server in the event of a Wake on LAN event.
Implication LDCM may not send or receive Wake on LAN events. This will result in the
server not being powered on as expected.
Workaround Make sure that both NICs are connected to the network. After doing this “Wake
on LAN” will perform as designed.
Status Intel is investigating the possibility of fixing this erratum.
8. Windows 2000* won’t install on a Maxtor D540X-4G 137GIG
ATA hard-drive
To Next Page
Loading...
