SE7500CW2 Server Board Technical Product Specification System BIOS
65
Revision 1.40
6.5.8 Power Menu
To access this menu, select Power on the menu bar at the top of the screen.
Main Advanced Security Power Boot System Exit
Table 30 lists the options available on the Power menu. This menu is designed to disable ACPI
automatic reboot in the S0 or S4 states. If these submenus are enabled and AC power is lost,
the server power and its operating system will remain off.
Table 30: Power Menu
Device Description
Power Loss Control Stay Off
Last State
(default)
Specifies the power level the system returns to after
AC power is lost.
Stay Off leaves the server power disabled and ACPI
does not function to reboot the server in the event of a
power failure..
Last State reboots the system according to ACPI
standards..
Power Button Disable
Enable
(default)
Enables or disables the power button functionality.
6.5.9 Boot Menu
To access this menu, select Boot on the menu bar at the top of the screen.
Main Advanced Security Power Boot System Exit
Table 31 lists the options available on the Boot menu. This menu allows you to set the boot
priority of devices installed in the system. Use the following key combinations to navigate
between or view the devices and change the boot priority:
1. <Enter> expands or collapses devices with a “+” or “-.”
2. <CTRL + Enter> expands all devices.
3. <Shift+1> enables or disables devices.
4. <+> and <-> moves the device up or down.
5. <n> May move the removable device between the hard drive or removable disk.
6. <d> Removes a device that is not installed.
To Next Page
Loading...
