Intel True Scale Fabric 12000 Series - Log System Configurator: Preset Tab

Intel
®
True Scale Fabric Switches 12000 Series
July 2015 User Guide
Doc. Number: G91930 Revision: 005US 29
To change the log level settings:
1. Click the On-Off check box to the right of the setting(s).
2. Click the Apply button to save any changes.
3.2.1.4 Syslog Host Tab
The Syslog Host tab (Figure 3-7) allows the user to configure logging messages to be
sent to a syslog host through an IP address or domain name server (DNS) host name.
Note: In order to avoid losing log information in the event of a hardware failure, users should
configure a syslog server.
The switch only saves the in-memory log when it is able to gracefully shutdown, and
restore the log from the persistent state when it boots. Power cycling the switch,
removing/resetting the management card or any hardware failure that causes an
ASYNC reboot will not persistently save the in-memory log.
Note: If the Host IP address is 0.0.0.0, no syslog host is configured, otherwise log messages
are sent to the syslog server at a specified IP address and port.
Figure 3-6. Log System Configurator: Preset Tab