Intel True Scale Fabric 12000 Series - Configuring the Switch Default Gateway IP Address; Set OOB LAN Ipv6 Window; Set Switch Default Gateway IP Address Button

Intel
®
True Scale Fabric Switches 12000 Series
User Guide July 2015
64 Doc. Number: G91930 Revision: 005US
8. To automatically configure and assign addresses from an IPv6 router, click the
Auto Config Enabled radio button.
Note: The IPv6 router must be configured to assign addresses using stateless address auto
configuration.
9. Click Apply.
3.9.2 Configuring the Switch Default Gateway IP Address
The Set Default Gateway IP window allows the user to configure the IP address for
the default gateway to route packets from the OOB management port to an external
network.
To configure the Switch default gateway IP address:
1. From the menu, select OOB LAN IP.
The Set Default Gateway IP button is displayed (Figure 3-60).
2. Click Set Default Gateway IP.
The Set Default Gateway IP window is displayed (Figure 3-61).
Figure 3-59. Set OOB LAN IPv6 Window
Figure 3-60. Set Switch Default Gateway IP Address Button