Intel
®
True Scale Fabric Switches 12000 Series
User Guide July 2015
38 Doc. Number: G91930 Revision: 005US
SNMP Target Addresses:
• Address Name
Specifies a unique, administrator-defined name the system uses to identify a row.
• Transport Domain
Specifies the transport type of the address contained in the
snmpTargetAddrTAddress object (e.g., 1.3.6.1.6.1.1 = udp,
1.3.6.1.4.1.1977.200.1 = tcp).
• Transport Address
Specifies the IP address in dotted decimal format.
Note: The combination of the Transport Domain and the Transport Address determines the
trap destination.
• Port
Specifies the TCP or UDP port where the SNMP trap is sent.
• Timeout
Specifies the time (in milliseconds) that the trap sender waits on a response before
re-sending the trap.
• Retry Count
Specifies the number of attempts to be made to send the trap after a timeout
condition occurs.
Note: Timeout and Retry Count are SNMP v2.c and above (not applicable for v1 traps).
• Tag List
Specifies which traps should be sent to this particular destination.
Note: RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag List specifies
that the trap receiver will get link up/down traps.
• Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table, determining
the version of SNMP to use.
• Storage Type
This field determines whether or not the entry is saved for each reboot of the
switch.
— Nonvolatile means that the value is saved, and remains after each subsequent
reboot.
— Volatile or Other indicates it will not be saved.
• Status
Indicates the current status of the row. The row may be in one of three states:
— Active
— Not in service
— Not Ready
Note: A status of not in service indicates that the current row will not be used in the event a
trap is generated by the system. Toggling a trap to not in service, which temporarily
suspends trap forwarding, may be useful to keep values intact.
SNMP Target Parameters:
Note: Changes can only be made to rows that have a status of not in service.
• Parameter Name
To Next Page
Loading...
