35
ANTENNA INSTALLATION
The bolts used for tightening the Support Frame should be two M10x35L Hex Wrench Bolts
including an M10 Spring Washer and Flat Washer. This procedure must be performed on
both the left and right EL Arms.
After tightening both sides of the EL Arms, the middle of the frame should be tightened as
shown in the gure 27.
Figure 27. Tighten EL Arm Support Frame
Figure 28. Move GPS Location
GPS Location
The GPS unit should be moved from the surface of the Control Board Case to the
end of the EL Arm Counterweight Plate. Double sided tape attached on the GPS
will make it easy to move and secure to the EL Arm Counterweight Plate.
Initial Location
New Location
To Next Page
Loading...
