Intellian v240M - Page 41

41
ANTENNA INSTALLATION
Assemble the Ku Module Support Frame and Feed Horn as shown in gure 41.
Assemble the Ku Module and Reector Support Pipes using M8 x 70L Hex Wrench Bolts as
shown in gure 42. The Ku Module should be connected to both the left and right pipes.
Figure 41. Ku Module Support Frame and Feed Horn
Figure 42. Ku Module and Reector Support Pipes
Two M6 x 90L
Hex wrench Bolts
and Nuts
A M6 x 20L Hex Wrench Bolt
and Nut
Four M5 x 30L Hex Wrench Bolts
and Nuts
Reector Support Pipes.