Intellian v240M - Page 40

v240M – Marine Satellite Communication System
40
Insert the Ku Module in the direction of the red arrow shown in gure 39. Be sure that your
Ku Module looks the same as 1 in gure 39.
While inserting the Ku Module, be sure that the lower part is caught into the groove joint.
Use four M6 x 20L Hex Wrench Bolts when tightening the module and the Groove Joint.
Figure 38. Cut Cable Ties
Figure 39. Connect Ku Module and Ku Module Support Frame
Figure 40. Ku Module Caught into the Groove Joint
Assembling Ku Module and Feed Horn
Cut the cable ties which are holding Reector Support Pipe.
1