39
ANTENNA INSTALLATION
Fix the position of the Ku Module Support Pipe to match the holes. When the holes on
the frame and pipe hole match, screw them together using M8 x 70L Hex Wrench Bolts
temporarily.
Tighten four M6 x 20 Hex Wrench Bolts rst as shown in gure 36, and then tighten the M8
Bolts which were applied temporarily in gure 35.
Connect the Waveguide and Flexible Waveguide together using four M4 x 20 Bolts and nuts.
Figure 35. Match the Holes
Figure 36. Tighten Bolts
Figure 37. Connect the Waveguide and Flexible Waveguide
To Next Page
Loading...
