Interlogix NS3552-8P-2S-V2 - Page 338

Chapter 6: Command line mode
336 NS3552-8P-2S-V2 User Manual
9600
Example:
Set 2048 frame size for port1
NS3552
-8P-2S-V2:/>
port maxframe 1 2048
Port Power
Description:
Set or show the port PHY power mode.
Syntax:
Port Power [<port_list>] [enable|disable|actiphy|dynamic]
Parameters:
<port_list>: Port list or 'all', default: All ports
enable : Enable all power control
disable: Disable all power control
actiphy: Enable ActiPHY power control
dynamic: Enable Dynamic power control
Default Setting:
disable
Example:
Disable port power function for port1-4
NS3552
-8P-2S-V2:/>
port power 1-4 enable
Port Excessive
Description:
Set or show the port excessive collision mode.
Syntax:
Port Excessive [<port_list>] [discard|restart]
Parameters:
<port_list>: Port list or 'all', default: All ports
discard : Discard frame after 16 collisions
restart : Restart backoff algorithm after 16 collisions
(default: Show mode)
Default Setting:
Discard
Example:
NS3552
-8P-2S-V2:/>
port excessive 1 restart
Port Statistics
Description:
Show port statistics.
Syntax:
Port Statistics [<port_list>] [<command>] [up|down]
Parameters:
<port_list>: Port list or 'all', default: All ports
<command> : The command parameter takes the following values: