20 ZeroWire User Manual
Your security system must be disarmed (turned off) before being able to bypass zones.
After bypassing your selected zones, your security system must be armed (turned on) in
either the away or stay mode to secure the remaining zones.
The status light will turn to yellow to indicate there are one or more bypassed zones.
Touch the status key to check which zones are bypassed.
5.
BYPASS
Select Bypass Menu
6.
Enter PIN code with authority to bypass
7.
Select a zone to bypass
8.
Toggle between un-bypassed to bypassed
state
9.
Exits from Bypass Menu
Event History
The Event History menu is used to listen to events that occurred in your security system.
These events include arming, disarming, system faults and alarmed zones. Ensure your
clock is set correctly as all events are time stamped.
“Alarm Memory” will announce the last zone(s) that caused your security system to go into
an alarm condition:
1.
HISTORY
Select History Menu.
2.
3.
Listen to the last alarm memory event.
4.
Exits from History Menu.
It is recommended you record user names, zone names, and outputs names in Menu 8 –
Recordings. This will make reviewing any events much clearer as ZeroWire will announce
the recorded name.
You may also review all events recorded by your security system:
USER PIN CODE ENTER
ZONE NUMBER ENTER
0
MENU
YOUR 4 TO 8 DIGIT MASTER CODE
ENTER
1
MENU
To Next Page
Loading...
Need help?
General
