Intermec EasyCoder F4 Installation & Operation Manual

Intermec EasyCoder F2 – Installation & Operation Ed. 2 51
Chapter 6 Setting Up the Printer
Setup Parameters, cont'd.
Print Defi nes, cont'd.
Test Label #1
Test Label #2
Test Label #3 Test Label #4
Test Label #5a
706 ohms/8 dots
CODE39
CODE39
UART1 9600-8-N-1 RTS/CTS DISABLE ENQ/ACK DISABLE XON/XOFF DATA TO HOST DISABLE DATA FROM HOST DISABLE NEW LINE CR/LF REC BUF 300 TRANS BUF 300 PRINT CONFIG STARTADJ 0 STOPADJ 0 XSTART 24 WIDTH 424 LENGTH 1800 MEDIA TYPE LABEL (w GAPS) PAPER TYPE DIRECT THERMAL LABEL CONSTANT 85 LABEL FACTOR 40
CONTRAST +0% TESTFEED 12 3 HEAD RESIST 706 PRINT SPEED 100 Odometer [km] 0 Model F2 Hardware version 3.0 Ram 4096 ( k) Flash 0+2048 +1016 (k) External 0 (k) c: 1819504 bytes free FIRMWARE Fingerprint 7.31 MCS1147 xx-mrs-00 xx:xx:xx m3k slav0782 27-MAY-97 17:09:25 [0] No keyboard slave [1]
Test Label #5b

Intermec EasyCoder F4 Specifications

General

Brand	Intermec
Model	EasyCoder F4
Category	Printer Accessories
Language	English