Intermec EasyCoder F4 Installation & Operation Manual

Intermec EasyCoder F2 – Installation & Operation Ed. 2 53
Chapter 7
The method of entering the Setup Mode depends on whether the
printer is fi tted with some kind of startup fi le, a subject that was more
thoroughly discussed in the chapter 4 “Starting Up” earlier in this
manual, to which the alphabetic references below refer.
A. EasyCoder F2 with Intermec Shell
• Turn on the power.
• When the display shows the message “Enter=Shell; x sec.”,
press <Enter>.
• Press the <Setup> key (this facility can be used anywhere
within Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing the <Setup> key.
B. EasyCoder F2 with a custom-made application program
• Normally, there will be no need to enter the Setup Mode
for custom-made application programs. Necessary provisions
for changing the setup, manually or automatically, should be
provided by the program.
Entering
Setup Mode
at Installation
Setup Mode

Intermec EasyCoder F4 Specifications

General

Brand	Intermec
Model	EasyCoder F4
Category	Printer Accessories
Language	English