Intermec EasyCoder F2 – Installation & Operation Ed. 260
Chapter 8
Intermec Shell is a so called startup program (also called “autoexec-
fi le”), i.e. a program that automatically starts running when the
printer is turned on. Intermec Shell helps the operator to choose
between a number of standard or custom-made application programs
and to start certain useful facilities, as listed below.
Application Programs
• Intermec LabelShop (WYSIWYG label design program)
• Intermec Windows Driver (for printing Windows programs)
• Intermec Fingerprint (for creating your own programs)
• Intermec Direct Protocol (easy-to-use slave protocol)
• LINE_AXP.PRG (line analyzer program)
• Other application programs in the printer's memory
1
Other Facilities
• Setup Mode (manual setup from printer's keyboard)
• Print Setup (printing setup on label)
• Testfeed (formfeeds + auto-adjust of the LSS)
• Test Label (printing of test labels)
• Default setup (resetting all setup parameters to default)
• Update PC-card (downloading data from a computer
to a PC-card inserted in the printer, or
upgrading the printer's fi rmware from
a PC-card)
• Reboot (restarting the printer)
Intermec Shell is factory-installed in the printer's permanent
memory (device "rom:"). This implies that if you insert a memory
card with another startup fi le before you turn on the printer, or
if there is a startup fi le stored in the printer's permanent memory
(device "c:"), this startup fi le will be used instead of Intermec
Shell (see chapter 4;“Startup Files”).
Intermec Shell Startup Program
Introduction
1
/. A prerequisite is that the program is
provided with the extension “.PRG”.
However, some original Intermec utility
programs are excluded:
ERRHAND.PRG
FILELIST.PRG
LBLSHTXT.PRG
MKAUTO.PRG
LSS-SENSOR.PRG
SHELLXP.PRG
WINXP.PRG
To Next Page
Loading...
Need help?
General
