Intermec EasyCoder F4 Installation & Operation Manual

Intermec EasyCoder F2 – Installation & Operation Ed. 2 59
Chapter 7 Setup Mode
Setup Mode Overview, Part 5
(Intermec Fingerprint 7.31)
• Press Setup key to exit the Setup Mode.
SETUP:
NET-COM, NET1
SETUP:
PRINT DEFS
SETUP:
MEDIA
SETUP:
FEEDADJ
SETUP:
SER-COM, UART1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 1
Standard Setup Mode
See Overview Part 2
Standard Setup Mode
See Overview Part 2
Use keys . and 0–9 to enter netmask.
Use C-key to erase.
Use keys . and 0–9 to enter netmask.
Use C-key to erase.
NETWORK:
IP SELECTION
SETUP:
NETWORK
NETWORK:
IP ADDRESS
IP ADDRESS:
10.1.12.79
NETMASK:
255.255.0.0
NETWORK:
NETMASK
Use keys . and 0–9 to enter router.
Use C-key to erase.
NETWORK:
DEFAULT ROUTER
DEFAULT ROUTER:
10.1.12.1
RARP
BOOTP
DHCP
IP SELECTION:
MANUAL
CR
LF
NET-COM,NET1:
NEW LINE
NEW LINE:
CR/LF
If an optional an EasyLAN 100i interface board is fitted, additional menus will be displayed.

Intermec EasyCoder F4 Specifications

General

Resolution	203 dpi (8 dots/mm)
Function	Label Printing
Compatibility	Intermec printers
Print Method	Direct Thermal / Thermal Transfer
Max Print Width	104 mm (4.1 in)
Max Print Speed	6 inches per second
Connectivity	USB, RS-232
Operating System Compatibility	Windows
Media Type	Labels, Tags
Memory	8 MB SDRAM, 4 MB Flash