Intermec EasyCoder F2 – Installation & Operation Ed. 2 63
Chapter 8 Intermec Shell Startup Program
Select Other Facilities
As an alternative to selecting an application, you can step through a
number of other useful facilities:
• Setup allows you to enter the Setup Mode to set up the printer by
means of its built-in keyboard, see chapter 7 “Setup Mode”.
• Print Setup allows you to produce a printout of the printer's
current setup values (test label #5).
• Testfeed allows you to feed out a number of label, ticket, tag
or pieces of strip while the printer auto-adjusts its paper feed
and label stop sensor or black mark sensor. It is recommended
to perform a Testfeed operation each time you load a new roll
of labels (or similar).
• Test Label allows you to print a series of four test labels
(test labels #1 – #4) in order to test the printout quality and
printhead alignment. The labels are presented in an infi nite
loop, so you can print the series over and over again. Press
<Enter> for each new label.
• Default Setup allows you to reset all setup parameters to their
respective default values, as listed in chapter 6.
• Software Update is used for two purposes:
- Update PC-card allows the printer to be used as a Flash
PC-card programming device. By means of the Zmodem
commun-ication tool, fi les can be downloaded from a PC
to a Flash PC-card
1
inserted in the memory card slot in
the printer's rear plate.
Warning! If the Flash PC-card contains an earlier fi rmware
version than the one in the printer, the printer's fi rmware will
be downgraded without warning.
- Update fi rmware is used to upgrade the printer's fi rmware from
a new fi rmware version stored as a fi le in a PC.
• Reboot has the same effect as turning off and on the power to
the printer. To exit Intermec Shell without having selected any
application program, use Reboot or restart the printer. Then wait
for the 5 seconds countdown without taking any action, and the
last selected application will be opened.
Starting Up with
Intermec Shell,
cont'd.
1
/. Only Flash PC-cards approved
by Intermec can be used.
To Next Page
Loading...
Need help?
General
