Intermec IF30

Chapter 1 — Getting Started
12 IF30 Fixed Reader User’s Manual
2 With Ethernet selected in the IF30 RFID Reader
Configuration menu, press the right arrow. The Ethernet
menu appears.
3 Configure these settings:
Or, press the down arrow key to select IPv6 Configuration,
and then press the right arrow key to configure these IPv6
settings:
4 (Optional) To configure DNS settings, choose Network
Services and press Enter. The Network Settings screen
appears.
DHCP Mode
Set to Disable DHCP.
IP Address A unique IP address.
IP Subnet
Mask
The subnet mask that matches the other
devices in your network.
IP Router
(Gateway)
If the IF30 will communicate with devices on
another subnet, enter the address of the router
that will forward frames.
Enable
Autoconfiguration
Enables automatic assignment of a
unique address to this IF30.
IPv6 Address A unique 128-bit IPv6 address.
IPv6 Subnet Mask The IPv6 subnet mask. Range is 1 to
128 bits.
IPv6 Router
(Gateway)
A unique 128-bit address for an IPv6
router.