4.1.1.B Supervisor Code (user #2)
The Supervisor code is a special code stored in user
location two. This code has limited access to Program
mode, including commands:
• Adding/Deleting Users (commands #50, #51,
#52, #53, #57, and #58)
• Enabling/Disabling Users (command #56)
• Changing Lock Output Time (command #11)
• Changing Keypad Platform Parameters 5 and 6
(command #32)
By default, user location two is empty, which means
that if you need a Supervisor code, you must program
one. To program a Supervisor code, press:
2 # new supervisor code *
new supervisor code *
(example, 2 # 5678 * 5678 *)
To enter Program mode using the Supervisor code,
press:
99 # supervisor code *
4.1.1.C Master Code and Supervisor Code
Special Features
The following is list of items that pertain only to the
Master and Supervisor codes:
• The Master and Supervisor codes can only be pro-
grammed as standard user types
• The Master and Supervisor codes can be pro-
grammed as “card AND code” or “card OR code”
users.
• The M aster and Supervisor codes cannot be pro-
grammed as “card only.”
Chapter 4: Programming 4.1 Programming Overview
4-2 prox.pad plus Install/Program. Manual, PPP, D2
To Next Page
Loading...