4.2.4
Enabling/Disabling
Users Command
The56#set/clear#userLocation#commandallows
the Master Code or Supervisor Code to disable a par-
ticular user location without deleting that user.
To disable a user, enter:
56#1#userlocation#**
To enable a user, enter:
56#0#userlocation#**
• TheMasterCodecanNEVERbedisabled.
• The Master Code can disable the Supervisor user
(user # 2).
• The Supervisor can disable users 3-2000.
The Master Code user cannot be disabled, and the
supervisor user cannot disable his/her self. A disabled
Supervisor cannot access Program mode; a non-pro-
grammed user cannot be enabled or disabled (gener-
ates a program error).
4.2 Programming Users Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D2 4-13
To Next Page
Loading...