International Electronics prox.pad plus - E Programming Card ONLY Use; F Programming Code or Card

4.2.2.E Programming Card ONLY Use
Card ONLY use can be programmed with command
50. The programming sequence is as follows:
50 # user-type # user location # **
<present card>
4.2.2.F Programming Code OR Card
Finally, you can program a user for either Code OR
Card use as follows:
52 # user-type # user location # keypad
PIN* keypad PIN * <present card>
4.2 Programming Users Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D2 4-11