International Electronics prox.pad plus - Turning Audio Keypress Feedback ON;OFF

1. Place the prox.pad plus unit in Program mode.
Press:
99 # Master Code * (default is 1234)
A slow blinking yellow LED indicates that the unit
is in Program mode. A steady yellow LED, in
contrast, means that errors were detected during
programming. Error states can be cleared by press-
ing the asterisk * key.
2. To enable this feature, press:
30#1#1#**
The yellow LED continues to blink slowly.
3. To disable this feature, press:
30#1#0#**
The yellow LED continues to blink slowly.
4. Press * to exit Program mode.
4.4.4 Turning Audio
Keypress Feedback
ON/OFF
The A udio Keypress Feedback command enables the
sounder to beep once for each key press. This feature
provides an audio acknowledgment that a particular
key was pressed hard enough for the unit to under-
stand. The factory-shipped default setting is ON, but
it can be toggled ON and O FF as desired using com-
mand 30. NOTE: Acommonreasontoturnthisfeature
OFF is to prevent an unauthorized user from hearing
the audio feedback emitted when an authorized user
enters his/her code.
1. Place the prox.pad plus unit in Program mode.
Press:
99 # Master Code * (default is 1234)
A slow blinking yellow LED indicates that the unit
is in Program mode. A steady yellow LED, in
contrast, means that errors were detected during
programming. Error states can be cleared by press-
ing the asterisk * key.
2. To enable this feature, press:
30#0#1#**
4.4 Programming Keypad Options and Parameters Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D2 4-25