13 of 42
Safety-related information
Maintenance
¾
visible damage on a regular basis.
¾ Never open up the RollerDrive.
Unintentional start-up
¾ Ensure that the RollerDrive cannot be switched on unintentionally, particularly during assembly and
maintenance work or in the event of a fault.
2.6 Interface to other devices
The integration of the RollerDrive into a conveyor system can create additional potential hazards. Such potential
hazards are not covered by this operating manual and must be analysed during the development, installation and
commissioning of the conveyor system as a whole.
¾ Following the integration of the RollerDrive into a conveyor system, the entire system must be checked for any
new potential hazards that may be present before the conveyor is switched on.
2.7 Operating modes/operating phases
Standard operation
Operation in the installed condition at the end customer as a component in a conveyor in an overall system.
Special operation
Special operation encompasses all operating modes/operating phases that are necessary to guarantee and maintain
safe standard operation.
Special operating mode Comments
Transport/storage -
Assembly/commissioning In de-energised state
Cleaning In de-energised state
Maintenance/repair In de-energised state
Fault location -
Troubleshooting In de-energised state
Decommissioning In de-energised state
Disposal -
To Next Page
Loading...
Need help?
General
