35 of 42
Maintenance and cleaning
7 Maintenance and cleaning
WARNING
Risk of injury from following incorrect procedure.
¾ Maintenance and repair work must only be carried out by authorised and trained (specialist) personnel.
¾ Maintenance and repair work must only be carried out when the system has been disconnected from the
on again.
¾ Put up signs to indicate that maintenance or cleaning work is being carried out.
7.1 Maintenance
Checking the RollerDrive
If the RollerDrive is not secured according to the installation instructions (see „Installing the RollerDrive“ on page 26),
¾
tighten it with a torque spanner if necessary.
¾ Check the RollerDrive every month for any visible damage.
¾
Replacing the RollerDrive
If a RollerDrive is damaged or defective, it must be replaced.
Do not attempt to open the RollerDrive.
¾ Install a new RollerDrive (see „Decommissioning“ on page 38 and „Installing the RollerDrive“ on page 26).
To Next Page
Loading...
