Assembly and installation
5.2 Installing the RollerDrive
Installing the attachment shaft
NOTE
Internal parts of the RollerDrive can be damaged through improper handling.
¾
¾
¾
supporting structure, etc.). Improper earthing can lead to a build-up of static charge, which can result in a
malfunction or premature failure of the RollerDrive and/or the connected control.
¾ Remove packaging material and transport protection from the RollerDrive.
To guarantee safe equipotential bonding of the RollerDrive, the fastening nut must be in direct contact with
¾
¾ Insert the RollerDrive cable and attachment shaft into the hex hole provided (min. 11.2 mm) or round hole (min.
¾ Position one or two round belts of 4 mm (max. 5 mm) or PolyVee belts.
To Next Page
Loading...
