Safety-related information
2.5 Dangers
with the operation of the RollerDrive.
Injury to persons
¾ Maintenance and repair work on the unit must only be carried out by authorised technical personnel in
compliance with the applicable provisions.
¾ Before switching on the RollerDrive, ensure that no unauthorised personnel are situated in the vicinity of the
conveyor/conveying system.
Electricity
¾ Installation and repair work must only be carried out when the system has been disconnected from the power
supply.
¾
Rotating parts
¾
¾ Persons with long hair should wear a hair net.
¾
¾ Do not wear items of jewellery such as chains or bands.
Heat
¾ Do not touch the RollerDrive during operation. In applications with high switching cycles, the temperature of the
tube can reach up to 60 °C.
Work environment
¾ Remove any materials and objects that are not required from the working area.
¾ Wear safety shoes.
¾ Stipulate that the material to be conveyed must be set down carefully and monitor this to ensure it is carried
out correctly.
Faults in operation
¾ Regularly check the RollerDrive for visible damage.
¾ In the event that smoke begins to form, unusual sounds are heard or the conveyed material becomes jammed
unintentionally switched on again.
¾ Immediately contact specialist personnel to determine the cause of the malfunction.
To Next Page
Loading...
Need help?
General
