INVT EC160 - Parameters Setting-Communication Setting

User manual of EC160 elevator intelligent integrated machine Function parameters
98
Function
code
Instruction Setting range【default value】 Remarks
P5_11 Braking threshold voltage 320~750【700】
Not modify
in running
The 220V integrated machine should be changed into 380V.
6.5.7 Parameters setting---communication setting
【main menu】
A system control
B fault record
C language selection
D parameters setting
inquiry
E password setting
F system autotuning
G data management
H system information
【parameters setting
inquiry】
P0 master drive
control
P1 speed and
deceleration distance
P2 motor parameters
P3 encoder
parameters
P4 running
comfortability
P5 elevator protection
parameters
P6 communication
setting
P7 drive information
PE factory only
【P6 communication
setting】
00 Local communication
address
01 Communication baud
rate selection
02 Data format
03 Communication
response enabling
04 Communication
response delay
05 Communication
timeout fault
06 Reserved
07 Reserved
08 Ethernet
communication speed
setting
09 Ethernet IP address 1
10 Ethernet IP address 2
11 Ethernet IP address 3
12 Ethernet IP address 4
13 Set the subnet mask 1
14 Set the subnet mask 2
15 Set the subnet mask 3
16 Set the subnet mask 4