INVT EC160

User manual of EC160 elevator intelligent integrated machine Function parameters
76
forced
speed-changing
6 high speed up forced
speed-changing
7 down limit
8 up limit
9 emergency electric
running
contactor
19 contact of the
brake contactor
door lock
27 hardware enabling 28
pre-opening feedback
29 pre-opening
adhesion
6.2.5 System monitoring---car controller
【main menu】
A system control
B fault record
C language selection
D parameters setting
inquiry
E password setting
F system autotuning
G data management
H system information
【system control】
[1] calling and
running state
[2] random running
[3] drive state
[4] main controller
[5] car controller
【car input signal 1-16】
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
【car output signal 1-13】
1 2 3 4 5 6 7 8
9 10 11 12 13
【use the up/down key
to turn page and inquire
the state and function】
Check the changing of each point when the input/output point on the car top board EC-CTB and
use the UP/DOWN key to turn page and inquire the definition of the output/input point.
6.3 Fault history record
【main menu】
A system control
B fault record
C language selection
D parameters setting
inquiry
E password setting
F system autotuning
G data management
H system information
【fault record】
The 1
st
one of 3
Fault code: 30 Floor: 1
2010-12-10 23:24:12
Fault instruction:
30# safety circuit fault
【press ENT to check
the fault state】
The system state when
the fault occurs
Input state 1: 0000
Input state 2: 000E
Input state: 000
Elevator speed: 0m/s
Car position: 70mm
Bus voltage: 0557.8
Current when fault
occurs: 0000.0A
Running frequency:
000.0Hz
【press ENT to return】