INVT Goodrive 200A

Goodrive200A inverters Keypad operation procedure
26
No.
Name
Description
during the parameter modification
Run key
This key is used to operate on the
inverter in key operation mode
Stop/
Reset key
This key is used to stop in running state
and it is limited by function code P07.04
This key is used to reset all control
modes in the fault alarm state
Quick key
The function of this key is confirmed by
function code P07.02.
5.3 Keypad displaying
The keypad displaying state of Goodrive200A series inverters is divided into stopping state
parameter, running state parameter, function code parameter editing state and fault alarm
state and so on.
Fig 5-2 Displayed state
5.4 Keypad operation
Operate the inverter via operation panel. See the detailed structure description of function
codes in the brief diagram of function codes.
5.4.1 How to modify the function codes of the inverter
The inverter has three levels menu, which are:
1. Group number of function code (first-level menu)
2. Tab of function code (second-level menu)
3. Set value of function code (third-level menu)
Remarks: Press both the PRG/ESC and the DATA/ENT can return to the second-level menu
from the third-level menu. The difference is: pressing DATA/ENT will save the set
parameters into the control panel, and then return to the second-level menu with shifting to
the next function code automatically; while pressing PRG/ESC will directly return to the
second-level menu without saving the parameters, and keep staying at the current function
code.
Under the third-level menu, if the parameter has no flickering bit, it means the function code