Ioline FlexJet - Chapter 1 Overview; Getting Started

In order to output to the FlexJet,
your apparel design software must
create plot les in HPGL 7475
or DM/PL format. Alternatively,
you can output markers using the
FlexPlot software, included with
the FlexJet. FlexPlot imports and
converts a variety of le formats
for output to the FlexJet.
Getting Started
Thank you for purchasing the Ioline FlexJet.
This manual contains instructions and guidelines for setting up,
operating and maintaining the Ioline FlexJet printer. The following
components are needed to create markers:
n A FlexJet assembled according to the directions outlined in the
FlexJet Quick Start Guide.
n A computer system that is properly installed and has a func-
tioning serial or USB port.
n Apparel design software loaded into the computer according to
the installation instructions.
n Printing media and ink cartridges that are within the guidelines
stated under the Operation chapter.
n Depending on the communications setup, Ioline FlexPlot soft-
ware is required if your CAD software does not create compat-
ible les.
Note
i
The Ioline Control Center
and FlexPlot will only run on
the Windows® 98/NT/2000/XP
operating systems. Most design
software provides drivers for
Ioline printers. Contact Ioline
customer service if you need as-
sistance with drivers.
Note
i
Overview
Chapter 1