48
Ioline FlexJet User Guide
Manually Updating Firmware
using a Terminal Program like
TeraTerm
™
(For rmware versions 247.x and older)
Summary
1. Prepare the FlexJet.
2. Set up TeraTerm
™
.
3. Update the rmware.
Prepare to Update the Firmware
1. Power on the PC and FlexJet.
2. Ensure that the
serial cable is connected between the PC and
the FlexJet.
3. Copy the rmware le to a folder like
c:\Ioline\Firmware or
another location that is easy to remember.
Setup TeraTerm
1. Start TeraTerm
™
. (Please contact Ioline if you need a copy.) It is
included on the FlexJet CDROM in the X:\tools (where X is the
CDROM drive letter) folder.
2. When the New Connection window appears, click on the
circle next to Serial then select the COM port that connects the
printer to the PC.
3. In the main TeraTerm
™
window menu, click on Setup>Serial
Port.
4. Make sure the settings match the following:
a. Data: 8 bit
b. Parity:
None
c. Stop:
1 bit
d. Flow Control:
Xon/Xoff
e. Transmit Delay:
0/0
5. Press OK.
If the rmware le is a ZIP
archive, make sure it is decom-
pressed before sending it to the
FlexJet. You can download a ZIP
decompression utility at
http://www.winzip.com if
necessary.
Note
i
To Next Page
Loading...
