70
Ioline FlexJet User Guide
70
Ioline FlexJet User Guide
Q
Quality 22—See Printing quality
LED Lights on keypad 22
Queue management 18
R
Radio frequency 60
Rear dancer bar 31, 62
Red light mode 62—See also STOP mode
Removing markers—See Markers Removal
Repair ix, 57, 58
Factory authorization ix
Reset Serial Port Baud Rate
Button combination 23
Reset serial port baud rate 23
Resolution 62—See also Printing resolution
Restore Factory Default Settings
Button combination 23
Restore factory default settings 23
Right end cover x
Roll feed 62
Roll Up 23
Button combination 23
S
Safety
Lifting printer by gray bars ix
Removing markers 35
Safety precautions ix
Take-up key 30
Safety cover x
Scale 26
Scan 62
Scan alignment—See Frame gap
Screen menu options—See Control Center
Segments (of a plot or marker)—See Plot
Select alignment plot 43
Send Command 25
Sending plot les 34
Send plot le 25
Send size plot 41
Send to queue 34
Sensor xii, 23, 62
Serial communication 62—See also Communications
Serial port xi, 13, 15, 16, 17, 23, 52, 62
Conguration 16
Data bits 17
FlexPlot set-up window 17
Flow control 17
Location on computer 16
Location on FlexJet 16
Parity 17
Setup 16–17
Stop bits 17
Service loop 62—See also Feed loop
Service Station ix, xii, 19, 22, 31, 34, 41, 44, 45, 46, 49, 50,
53, 62
Set alignment 43
Set calibration 41
Set gap 44
Set motion 43
Set origin 22, 34, 35, 40, 42, 54, 56, 62
‘V’ notch on carriage 22
Button 22
Size calibration 25, 40, 41
Software—See also Firmware
Apparel design software 13, 15, 17, 22, 26, 34, 51, 52, 54,
55, 59, 61, 62
Control Center 13, 15, 16, 17, 19, 24, 25, 26, 28, 41, 42,
46, 49, 52, 54, 55, 56
FlexPlot 13, 15, 16, 17, 18, 19, 28, 34, 35, 52
Setup 17
Software version 26—See also Firmware
Special keycombinations 23
Square light 19, 23, 24, 29, 34, 53
Square Shaft 62
Stall xii, 27, 28, 44
Stand x, 15, 32, 36
Assembly & Leveling 15
Cross-member xi
Stand leveling foot x
Start/Stop 21, 22, 23, 31, 34, 35, 44, 45, 52, 62
Button 21
To Next Page
Loading...
