ircon Modline 5 - Page 120

RS-485 Digital Communications
118
Rev. L6 Feb 2017 Modline 5
Code
Command
Description
Type
Group
Notes
SW
Switch input status
R/O
Head
Returns the Sensor’s external Peak Picker reset and Hold mode
select switch status.
TI
Temperature, status
and attenuation
R/O
Head
Returns the temperature, current status and the current attenuation
percentage.
TO
Temperature Only
R/O
Head
Returns the temperature the unit is reading. No alarm or special
values are reported for over range and under range conditions.
TP
Controller type
R/O
Eng.
Reserved for future use. Always returns 0.
TS
Temperature and
Status
R/O
Alarm.
Returns the temperature the unit is reading and the Presence of an
alarm.
TT
Temperature
R/O
Head
Returns the temperature the unit is reading in the current units (F or
C) Special bit mapping messages for measurement status.
UF
Unit full scale
R/O
Eng.
Returns unit’s full-scale temperature as defined by Model No.
UN
Units select
R/W
Eng.
Sets the units the Sensor uses for measurement (F or C).
UZ
Unit zero scale
R/O
Eng.
Returns Sensor’s zero scale temperature as defined Model No.
VR
Firmware version
R/O
Eng.
Returns the Sensor’s firmware version number