2.6.1 Sensor Specifications
Spectral Response
Series 52 0.85 to 1.1 microns
Series 56 2.0 to 2.8 microns (Model 56 to 0315 only)
2.3 to 2.6 microns (All other models)
Series 5G 1.6 microns
Series 5R Ratio Mode: 0.75 to 1.05; 1.0 to 1.1 microns
Single Color Brightness Mode 1.0 to 1.1
* All specifications subject to change without notice.
Calibration / Blackbody Accuracy at 25°C
Sensor Series 52 Within 0.3% of reading plus 1°C up to 2800°C (5072°F)
indication up to 3000°C (5432°F)
Sensor Series 5G Within 0.3% of reading plus 1°C
Sensor Series 56 Within 0.3% of reading plus 1°C, or
2C (whichever is greater)
Sensor Series 5R Within 0.5% of reading plus 2°C up to 2800°C (5072°F)
indication up to 3000°C (5432°F)
Repeatability at 25°C Within 0.1% of full-scale temperature (+1 digit)
Response Time for Display and Outputs
Series 5R Adjustable from 0.01 to 60 seconds.
Series 52, 5G Adjustable from 0.0066 to 60 seconds.
Series 56 Adjustable from 0.020 to 60 seconds.
Selectable Analog Current Output 0 to 20 mAdc or 4 to 20 mAdc
600 Ω maximum load including cable resistance
Output is not isolated from power supply common.
Digital Communications RS-485 Digital Interface
Emissivity Range Emissivity is 0.10 to 1.00.
Series 52, 56, 5G and 5R (single color mode)
Emissivity Limitations for Series 5G and 56
Emissivity span is limited to 0.3 to 1.0 for the first 100°F
(55°C) for all temperature ranges of these models
E-SLOPE Range Model 5 R (Two color Ratio Mode) 0.800 to 1.200.
Signal Reduction Range Tolerated Sensor Series 5R will tolerate 95% reduction in radiation
intensity caused by low emissivity, non-resolved or obscured
To Next Page
Loading...
