ISHIDA INS-100 - Menu List

Chapter 2 INSTALLATION & SETUP
16 INS-100 Service Manual No. 085-6692-09
2.5.3 Menu List
No. Content Setup Value
F 1 Automatic power OFF function
0: Power OFF after a certain period of time.
1: Unit price and price display disappears after a certain
period of time (depending on country setting)
F 2
Invalid
(Preset automatic call function)
0: Invalid 1: Invalid
F 3
Invalid (Digit number change )
(when the printer is connected)
0: Invalid 1: Invalid
F 4
Invalid (Date print)
(when the printer is connected)
0: Invalid 1: Invalid
F 5
Invalid (Preset number print)
(when the printer is connected)
0: Invalid 1: Invalid
F 6
Invalid
(Tare and upper/lower limit print)
(when the printer is connected)
0: Invalid 1: Invalid
F 7
Invalid (Serial number print)
(when the printer is connected)
0: Invalid 1: Invalid
F 8
Invalid (Continual labels/Single
label specification)
(when the printer is connected)
0: Invalid 1: Invalid
F 9 Invalid (Baud rate) (RS-232C)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
4: Invalid 5: Invalid
F10
Invalid
(Serial output message
specification) (RS-232C)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
4: Invalid 5: Invalid
F11
Invalid
(Serial output method ) (RS-232C)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
F12
Invalid
(Serial output
condition)b(RS-232C)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
4: Invalid 5: Invalid 6:Invalid 7: Invalid
F13
Invalid
(Contact output signal setting)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
F14
Invalid
(Contact input signal setting)
(Contact point box)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
F15 Invalid (Large volume buzzer)
0: Invalid 1: Invalid 2: Invalid 3: Invalid
4: Invalid 5: Invalid
F16 Built-in buzzer output condition 0: Operation 1: Non-operation
F17 Automatic power OFF time setting
0: No function 1: 10 minutes 2: 20 minutes
3: 30 minutes 4: 40 minutes 5: 50 minutes
6: 60 minutes 7: 0.5 minutes 8: 1 minute
9: 5 minutes
Note: To exit this mode, press the [CLEAR] key.
F2 – F15 is Invalid function.