Quick Start
Copyright © ITECH Electronic Co., Ltd. 13
CR
Sets the load to CR mode and sets the resistance value.
CW
Sets the load to CW mode and configures the power value.
Enter
Confirms settings.
On/Off
Turns the instrument on or off.
Up key, to select menu items during menu operation.
Down key, to select menu items during menu operation.
Right key, to adjust the cursor to the specified location to set the
value.
Left key, to adjust the cursor to the specified location to set the
value.
OK
Confirms settings.
Enters numeric values for various parameters.
.
Decimal point.
ESC
Cancels the current action and returns to the previous menu.
×10
Rotary knob to adjust the setups by 10 stepping.
×1
Rotary knob to adjust the setups by 1 stepping.
2.4 Fast function key
A combination of front board keys and Shift composition keys in IT8800 Series
can realize functions marked at key bottom. For details, see table below.
Shift+1 (Short)
To start or end short circuit test.
Shift +2 (program)
Auto test function.
Shift +3 (Battery)
Battery test function.
Shift +4 (Save)
To save existing setting load parameter values, e.g.,
voltage, current and power.
Shift +5 (System)
To set system menu.
Shift +6 (Config)
To configure system menu.
Shift +7 (Info)
To display model, version number and serial number of
electronic load.
Shift +8 (Lock)
Keyboard locking function.
Shift +9 (Local)
LOCAL key, to shift local and remote operation.
Shift + CC (OCP)
OCP test function.
Shift + CV (Setup)
To set specific parameters of constant voltage, constant
current, constant resistance and constant power.
Shift + CW (OPP)
OPP test function.
To Next Page
Loading...
