ITech IT8800 Series - 3.2.2 Constant voltage operation mode (CV); Operation steps

Function and Features
Copyright © ITECH Electronic Co., Ltd. 22
Constant Current
Rise down=0.000A/uS
8. Complete parameter setting.
10.0000V 0.0000A
0.00W CC=1.000A
NOTE
If the above method is for editing auto test step (as mentioned below), constant current
range can also be set.
3.2.2 Constant voltage operation mode (CV)
Under CV mode, the electronic load will consume sufficient current to maintain
the input voltage at setting voltage. As shown in Fig. 3-2.
Fig. 3-2 Voltage-Current Relation Schema under CV Mode
Under CV mode, the electronic load provides three ways to modify constant
voltage.
 Under CV mode, rotate the pulse knob to change constant voltage value.
 Under CV mode, directly input numeric key and press [Enter] key for
confirmation to change constant voltage value.
 Under CV mode, move the cursor with Left/Right Key and press Left/Right
Key to adjust value at corresponding position.
Operation steps
1. Press [CV] key and [Shift] + [CV] to enter parameter setting screen.
Constant Voltage
Range=120.00V
2. Set maximum working voltage value and press [Enter] key for
confirmation.
Constant Voltage
Range=2.33V
3. Set maximum current value and press [Enter] key for confirmation.
Constant Voltage
High=66.000A
Set current
Load
voltage
I
V
Set voltage
CV mode