ITech IT8800 Series - 3.18 List operation (LIST)

Function and Features
Copyright © ITECH Electronic Co., Ltd. 44
EDIT LIST
Current Range=3A
4. Edit number of steps. Press 2 key to edit two steps. Press [Enter] key for
confirmation.
EDIT LIST
File Step=2 (2-84)
5. Edit current value in step 1And press [Enter] key for confirmation.
EDIT LIST
Step 001 Level=1A
6. Edit slope in step 1And press [Enter] key for confirmation.
EDIT LIST
Step 001 Rate=0.1A/uS
7. Edit time in step 1And press [Enter] key for confirmation.
EDIT LIST
Step 001 Width=5S
8. Edit current value in step 2And press [Enter] key for confirmation.
EDIT LIST
Step 002 Level=2A
9. Edit slope in step 2And press [Enter] key for confirmation.
EDIT LIST
Step 002 Rate=0.1A/uS
10. Edit time in step 2And press [Enter] key for confirmation.
EDIT LIST
Step 002 Width=5S
11. Edit repeat count and press [Enter] key for confirmation.
EDIT LIST
Repeat Count=3
12. Save all edited files and press [Enter] key for confirmation.
EDIT LIST
Save List File=1(1-9)
13. Operate Left/Right key and move to On. Press [Enter] key (The Trig lamp
that indicates VFD screen status is on). Press [Esc] key to exit setting.
LIST
On Recall Edit
List operation running
15. Press CC/CV/CR/CW key or any composite function key to exit List test
function.
For direct recall of existing List files and triggering of List operation, refer to
steps below:
Operation steps
1. Press [List] key and ensure that ON lamp flicks. If not, press [Enter]
before operating Left/Right key. Move to [Recall] and press [Enter] key.
LIST