Prover type
Honeywell SNAP
Measurement Systems
Energy Economics (EEI)
Can-Tronics
Itron BPG SONICAL SNG6
Proving the Intelis Gas Meter Using the Honeywell SNAP Proving System
This section provides the information to set up an Intelis Gas Meter using a Honeywell SNAP
proving system.
Note: Proving the Intelis Gas Meter requires Honeywell SNAP prover software .NET X.Y.
Temper meters unpackaged in the proving area for 24 hours prior to testing. If tempering is not
possible, complete steps 1-9 of Tempering the Meter by Exercising. If the meters are
tempered, continue to Setting Up the Prover.
Warning! Follow your company’s standard operating procedures regarding the use
of personal protection equipment (PPE). Adhere to guidelines issued by your com-
pany in addition to those contained in this document when proving meters.
Adjust the proving table to accommodate the height of the Intelis Gas Meter. If necessary, use
the Intelis Gas Meter prover stand (Itron part number FIX-7100-001). Place the prover stand on
the prover table and set the meter on the stand.
Itron recommends these Intelis Gas Meter Test Mode parameter settings for the Honeywell
SNAP proving system:
■
Test Mode pulse weight: 0.25 CF
■
Test Mode pulse width: 150 ms
Tempering the Meter by Exercising
1. Log on to the prover as a Supervisor.
2. Select Special Functions.
3. Select Diagnostics (local).
4. After the Diagnostics screen opens, clamp the meter in place by pressing Clamp in the
lower right screen corner.
5. Press the clamp buttons on both sides of the SNAP prover.
11 December 2019 TDC-1782-005 31
Intelis Gas Meter Installation Guide 5 Proving
To Next Page
Loading...
Need help?
General
